Page 1 of 1

fx verminator o ring

PostPosted: Sat May 04, 2013 2:15 pm
by tommelglenn
I am the proud owner of an fx verminator and once again find that the bottle appears to be leaking, but only when lateral pressure is applied when connected to the joint between rifle and bottle, I have found a diagram of an fx bottle

http://www.fxairguns.com/wp-content/upl ... rawing.pdf

and also a part list for the bottle web address is below

http://www.fxairguns.com/wp-content/upl ... rtlist.pdf

i noticed that location one on the partlist is "O-ring 9,3x2,4 NBR90" and looking at the bottle diagram this O-ring is on top or at least the first part you should see when looking in the bottle so to speak but I dont appear to have one????????? can someone pls upload a photo of the top of thier bottle (the brass top bit) looking inwards so I can see if I am missing a bit? and if I am where would you good people advise me get one and how much etc?

many thanks in advance of any help you can provide....